|
The SHURE-TRAC 4000 has a variable bladehead from 20" (508
mm) to 26" (660 mm).
Bladehead reciprocates on four precision linear bearings running
around two hardened and ground linear shafts.
Bladehead is CAPTURED during back and forth horizontal movement
preventing unwanted bladehead movement and eliminating inaccuracies and ridges
in cuts that are common with conventional saws.
Variable bladehead counterbalance
system reduces vibration during operation.
Solid stainless steel, full length bladehead safety guards.
Automatic four point positive displacement bladehead lubrication
system with .7 gallon oil reservoir.
Four cup die set dip lubrication system with .6 gallon oil reservoir.
Solid state electrical controls with lighted ON/OFF switch. All
controls are located on one panel.
Electronic safety sequence start and restart cycle.
|
One year warranty on all parts.
Excellent results with AT cuts,
high X-bars, seed bars, SAW devices and other specialty cuts. Variable bladehead
lengths available.
Standardized, readily available component parts used throughout
the machine.
Simple, one piece Pitman arm drive shaft with large aircraft type
rod ends.
Low maintenance, high torque belt drive system with oversized vertical
shaft bearings.
Easy to clean, 360 ° aluminum one piece yoke.
Abrasive system includes custom
reservoir, pump, filter, volume control, distribution manifold and exhaust
manifold drain.
Large, stable 4 post die set for accurate vertical cutting platform.
495 lbs. (225 kg) cast way bed for smooth, vibration free operation.
|
FAX: (913) 262-3685